Installation Manual v1.2:
Billet Flex Plate
Dodge Cummins
Please read all instructions before installation
WARNING: The ATS Billet Flexplate will not mate to a DTT torque
converter.
1. If the transmission is not removed follow the directions given in the
Transmission Procedure manual.
http://www.atsdiesel.com/PDF/Transmission_Installation-b_1.pdf
2. Remove the eight bolts securing the factory flex plate to the crankshaft
using an 18mm socket. Retain the factory spacer.
3. Install the ATS Billet Flex Plate using the 8-factory bolts and the factory
spacer. The spacer should be installed on the outside (same as original)
of the flex plate, Figure 1. Torque the crankshaft bolts to 105 ft-lbs. Try
to locate the oval shaped hole on the outer bolt circle over the access
plate in the engine block, so that the first torque converter bolt can be
installed in this location. This will make installation easier in the following
steps.
Download Installation Manual v1.2: Billet Flex Plate Dodge Cummins
Get the file Download here | PDF-HOME